Author Topic: Hybrid functionals in Riper? (TM7.1)  (Read 900 times)

mboehme

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Hybrid functionals in Riper? (TM7.1)
« on: September 09, 2016, 11:19:35 pm »
Hey,

I just want to know if the new module Riper also supports hybrid functionals in Version 7.1? In the manual it is stated: "no hybrid exchange-correlation functionals yet". However, I set up a test calculation and Riper confirms in the output the usage of B3-LYP. Can I trust these results? Thanks in advance!

Regards,
Michael

turbomaster

  • Administrator
  • Full Member
  • *****
  • Posts: 56
  • Karma: +0/-0
Re: Hybrid functionals in Riper? (TM7.1)
« Reply #1 on: September 10, 2016, 10:18:07 pm »
Riper does not support hybrid functionals. It should not have run if B3-LYP is specified. I will have to check why it did not.